Malaguti PHANTOM MAX 200 Bedienungsanleitung Seite 139

Change the engine oil and the oil filter cartridge
every 6000 km (3720 mi) or 12 months
· Warm the engine up for a few minutes, since the oil change
shall be carried out while the engine is warm.
· Turn the engine off. Put an oil collecting pan under the engine
cover, in correspondence with the cap (A – fig. 27).
· Remove the filler cap and the dipstick, (A – fig. 26) and then
drain the oil.
· Clean the internal mesh by means of compressed air.
· Check the cap's O-Ring conditions. Replace if necessary.
· Remove the cartridge oil filter with relevant O-Ring (B-fig.27) and
replace it.
· Before fitting the new cartridge filter, lubricate the relevant O-Ring,
and then tighten by hand.
· Reassemble the mesh and the oil filter cap with O-Ring.
· Top up the engine with oil and refit the filler cap with dipstick by
tightening it completely.
· Turn the engine on in order to fit the new filter cartridge and the
lubrication system. Turn the engine off and, after about 5 minutes,
check the oil level and, if necessary, top up until it reaches the
MAX notch
NOTE: the oil cartridge filter must be replaced every time oil
is replaced, along with its gasket.
Every 3,000km the message OIL is displayed on the digital
dashboard. This warning light indicates that it is time to
change the engine oil.
This warning light is displayed on the dashboard until the
above-mentioned operation is carried out by a Malaguti
Authorised Service Centre.
A
Fig. 27
Used oil is toxic for the environment, therefore we suggest
you contact a Malaguti Authorised Service Centre for oil
disposal according to the rules in force.
B
EN
35