Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Slide the four support beams included
in the packaging under the ramp.
Remove the wooden bars in front of the
wheels.
Pull the brake lever and push the appli-
ance down the ramp with the level
pulled.
or
Plug in the Intelligent Key.
Bring the safety switch into the "1" posi-
tion.
Set programme selector switch to trans-
port run.
Set the travel direction switch to "for-
ward".
Actuate the accelerator pedal.
Drive the appliance off the pallet.
Bring the safety switch into the "0" posi-
tion.
Install cleaning head
The procedure for changing the cleaning
head is described in the chapter "Mainte-
nance Tasks".
Note:
On some models, the cleaning head is al-
ready installed.
Installing the Brushes
The installation of the brushes is described
in the chapter "Maintenance Tasks".
Installing the Vacuum Bar
Insert the vacuum bar into the vacuum
bar suspension in such a manner that
the profiled sheet is positioned above
the suspension.
Tighten the wing nuts.
Insert the suction hose.
5
-
EN
Operation
DANGER
Risk of injuries. Never use the unit without
protective roof in areas where the opera-
tors can be hit by dropping objects.
Note:
To take all functions out of operation imme-
diately, bring the safety switch into the "0"
position.
Adjusting driver's seat
Operate the lever for the seat adjust-
ment and move the seat to the desired
position.
Release the seat adjustment lever and
lock the seat in place.
Turning on the Appliance
Take the seating position.
Plug in the Intelligent Key.
Bring the safety switch into the "1" posi-
tion.
Turn the programme switch to the de-
sired function.
If the relevant indication appears on the
display, perform the maintenance task.
Display
Activity
Maintenance
Clean the vacuum bar.
Vacuum bar
Maintenance
Clean the fresh water fil-
Fresh water Fil-
ter.
ter
Maintenance
Check vacuum lips for set-
Suction lip
ting and wear and tear.
Maintenance
Clean protective turbine
Turbine strainer
strainer.
Maintenance
Check brush for wear and
Brush head
tear and clean it.
Press Info button.
Reset the counter for the corresponding
maintenance (see "Care and mainte-
nance/resetting counter").
Note:
If the counter is not reset, the maintenance
indicator appears again with every start-up
of the device.
Check parking brake
DANGER
Risk of accident. Prior to every operation,
the parking brake must be checked for
proper function on a level ground.
Turn on the appliance.
Set the travel direction switch to "for-
ward".
Set programme selector switch to trans-
port run.
Gently depress drive pedal.
The brake must unlock audibly. The
machine must roll easily on a plane sur-
face. When the pedal is released, the
brake locks audibly. Switch off the ma-
chine and call the aftersales service if
the above-mentioned events do not oc-
cur.
21