Refuelling; Operation; Operating Programs - Kärcher MIC 70 Bedienungsanleitung

Steering wheel inclination adjustment pedal
1
Steering wheel height adjustment locking lever
2
1. Release the height adjustment locking lever and set the
steering wheel to the desired height.
2. Lock the locking lever.
3. Press and hold the inclination adjustment pedal and set
the steering wheel to the desired inclination.
4. Release the pedal.
5. Check the locks prior to travel commencement.
7.6

Refuelling

DANGER
Risk of explosion
Do not refuel in confined spaces.
Do not smoke and avoid open flames.
Ensure that no fuel gets on hot surfaces.
1. Switch off the ignition.
2. Open the tank cap.
3. Fill with fuel.
Only the fuel specified in the operating instructions may
be used.
4. Wipe of any spilt fuel and close the tank cap.
8

Operation

DANGER
Danger of crushing
Make sure that no persons are present in the vicinity of the
articulated joint or vehicle during operation.
When using the vehicle for towing, make sure that no per-
sons are located during operation between vehicle and
trailer.
CAUTION
Risk of burns
Only use the vehicle if all panels are attached.
ATTENTION
Risk of damage due to overheated hydraulic oil or
overheated motor!
In case of excessive hydraulic oil temperature or an exces-
sive coolant temperature, set the motor speed to idle mode
(do not switch off the motor).
Perform the measures in the "Malfunctions" section
ATTENTION
Risk of damage due to missing lubrication
If the warning light for the oil pressure lights up during op-
eration, immediately move the vehicle out of the danger
zone, switch off the motor immediately and rectify the fault.
CAUTION
Reduced stability due to attachments
Adjust the driving style.
8.1

Operating programs

ATTENTION
Risk of damage
Only choose the operating program selection when the ve-
hicle has been shut down.
TRANSPORT MODE FAST
1
TRANSPORT MODE SLOW
2
WORKING MODE
3
CREEPING MODE
4
1. Stop the vehicle.
2. Set the engine speed to low speed.
3. Travel direction selector switch to the NEUTRAL posi-
tion (switch at central position).
8.1.1 <Transport mode fast>
The travel speed is regulated using the accelerator. Max.
40 km/h
Note
In <Transport mode fast>, the traction of the vehicle is
50%; the maximum travel speed is at 100%. The speed fol-
lows the engine speed.
8.1.2 <Transport mode slow>
The travel speed is regulated using the accelerator. Maxi-
mum speed approx. 20 km/h
Note
In <Transport mode slow>, the traction of the vehicle is
100%; the maximum travel speed is at 50%. The speed fol-
lows the engine speed.
8.1.3 <Working mode>
Max. 20 km/h
Note
More information on the <Working mode> is given in chap-
ter 6.7 MIC 70 multifunction display / display .
8.1.4 <Creeping mode>
Forwards: Max. 5 km/h
Reverse: Max. 10 km/h
Note
More information on the <Creeping mode> is given in
chapter 6.7 MIC 70 multifunction display / display .
English 61