Astralpool Smart+ 60 Einbau- Und Betriebsanleitung Seite 13

5.3. Production level selection
- +
To select the desired production level, press the " " [1] / " " [14] keys until the production level light blinks. The system information screen [11]
will display the value of the production scale light [4]. The system will set its production to the desired level after a few seconds.
Fig. 20
In normal conditions, the production value [4] should be the same as the programmed value. If the salt level in the water is outside the permitted
range ("HIGH SALT" [7] or "LOW SALT" [6] alarms on), or there is a problem in the electrolysis cell ("ELECTRODES" [13] alarm on), however,
the production value [4] could be lower than the programmed and displayed value [11].
5.4. Salinity test
AstralPool Chlore Smart + systems have an integrated system to detect the salinity level of pool water. To run the test, press the "SALT TEST"
[9] key. During the test, the production light will range from 20%-80% of the salinity scale [5], alternately displaying "SALT" and "TEST" on the
system information screen [11]. Once the test is completed, the light will blink for a few seconds on the scale [5] on the detected salinity value
(see Fig. 21). The equipment will return to normal operating mode after a few seconds.
Fig. 21
O
The system might show lower than actual salt levels if the temperature falls beneath 20 C.
12