Original Accessories / Attachments; Before First Use; Inserting / Replacing Soldering Tips - Parkside PLS 48 A1 Bedienungs- Und Sicherheitshinweise

©

Original accessories / attachments

½
Use only the accessories detailed in the operating instructions. The
use of attachments or accessories other than those recommended
here could lead to you suffering an injury.
©
Before first use
©

Inserting / replacing soldering tips

CAUTION! DANGER OF BURNS! Allow the soldering
pencil to heat up without a soldering tip.
½
Remove a soldering tip only when the device has been switched
off and the soldering tip has cooled.
Turn the soldering tip out to replace it.
You must 'tin', i.e. thinly coat with solder, the soldering tip
using the soldering station for the first time and before using a new
soldering tip.
To do this follow these steps:
Insert the mains plug into a mains socket and press the ON / OFF
switch into position "I".
2
Turn the temperature regulator
flow and deposit a thin continuous film over the surface of the sol-
dering tip.
Safety advice / Before first use
to 2 and allow a little solder to
6
before
7
GB/IE 13