Original Accessories / Attachments; Use; Switching On And Off - Parkside PLP 100 Bedienungs- Und Sicherheitshinweise

©

Original accessories / attachments

½
Use only the accessories detailed in the operating instructions. The
use of attachments or accessories other than those recommended
here could lead to you suffering an injury.
©

Use

©
Switching on and off
Switching on:
Insert the mains plug into a suitable mains socket. Press the
ON / OFF switch
Maximum switched-on duration: 12 seconds
Switching off:
Release the ON / OFF switch
Pause: At least 48 seconds
CAUTION! Never heat up the device if it is not fitted with a sol-
dering tip.
ATTENTION! Never use in continuous operation mode. The flow
of electrical current controls the delivery of soldering heat. As soon
as the ON / OFF switch
heat drops. If the ON / OFF switch
ery of soldering heat rises. Pay particular attention to achieving an
even delivery of soldering heat to ensure the highest soldering quali-
ty. You can do this by not allowing the soldering tip
excessively hot.
Note: The device has a soldering light
ing area.
and keep it pressed.
4
.
4
is released, the delivery of soldering
4
Safety advice / Use
is pressed again, the deliv-
4
to illuminate the work-
3
to become
1
GB 13