Switching Off; Overheating Protection; Solder Sponge; Soldering - Parkside PLS 48 A1 Bedienungs- Und Sicherheitshinweise

Setting 5 = 500 °C maximum soldering temperature, e.g. for desolder-
ing large soldered joints

Switching off:

Note: After use always replace the soldering pencil
j
Press the ON / OFF switch
If the device is not being used, pull the mains lead out of the mains
socket.

Overheating protection:

This device has overheating protection. This is triggered by the device
reaching too high a temperature. The flow of current is interrupted. The
device switches off and the ON / OFF switch
The device is ready for use again after approximately 10 minutes. The
ON / OFF switch

Solder sponge

Q
CAUTION! The hot soldering tip
contact with a dry solder sponge
may be damaged.
j
The solder sponge
j
Moisten the solder sponge

Soldering

Q
— The soldering pencil has a rated output of 48 watts and is therefore
ideal for electronics soldering (see Figs. A, B).
— The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
into setting "0".
2
light illuminates again.
2
is used to clean soldering tips.
5
5
Using the product
light ceases to illuminate.
2
must never be placed in
7
, otherwise the solder sponge
5
before you use it.
into the holder.
1
GB 15