Ir Remote Control - Cameo SCUBA Bedienungsanleitung

SYSTEM INFORMATION
Access the selection menu by pressing MODE. Using the UP and DOWN buttons, now select the "System" menu option (bottom row) and con-
firm via ENTER. This will take you to the submenu to select the submenu options (see table, select via UP and DOWN, display information with
ENTER). Press MODE again to return to the main screen.
Menu
System
System
Firmware = Device firmware
Temp = Displays temperature of
LED unit
OpHours = Displays operating hours

IR REMOTE CONTROL

8
V1.xx
LED
°F/°C
Op.Time
xx:xxh
Aim the infrared remote control directly, within line-of-sight, at the infrared sensor installed on the
front side. The maximum range is approx. 8 meters.
(1x CR2025 battery for IR remote control included in deliver, remove insulating film before use)
BLACKOUT
BRIGHTNESS
STROBE
WAVE 1
WAVE 2
COLOR
Displays the device firmware
xx°C / xx°F
°F (= displays in degrees Fahrenheit)
°C (= displays in degrees Celsius)
Displays the total operating time in hours and minutes
The BLACKOUT button serves to switch off the lamp in the projec-
tor. Pressing the Blackout button again turns the lamp back on.
Press the BRIGHTNESS button and then the
set the brightness as desired.
Press the STROBE button and then the
the strobe effect as desired (see DMX table Channel 2).
Press the WAVE 1 button and then the
the rotation of Effect Wheel 1 as desired (see DMX table Channel
4).
Press the WAVE 2 button and then the
the rotation of Effect Wheel 2 as desired (see DMX table Channel
5).
Press the COLOR button and then use the
set one of the eight colors of the color wheel plus "open", the split
colors, and the color wheel rotation (see DMX table Channel 3).
and buttons to
and buttons to set
and buttons to set
and buttons to set
and buttons to