Ir Remote Control - Cameo ZENIT B200 Bedienungsanleitung

System Info
Firmware
Temperature
Operation Hours
MANUAL LOCKING FUNCTION
In addition to the ability to protect the lamp automatically from accidental and unauthorised operation (see "Settings" - "Auto-lock"), the con-
trols can also be locked manually. Press and hold the UP and DOWN controls simultaneously for approximately 5 seconds. If an attempt is made
to change settings, "Locked!" will appear in the display and changing the lamp's settings via the controls is no longer possible. After approx. 1
minute, the current operating mode is displayed again. To unlock, press and hold the UP and DOWN controls simultaneously for approximately
5 seconds.
The display will show the previously displayed information.

IR REMOTE CONTROL

14
= Displays device
firmware
= Displays temperature of
LED unit
= Displays operating time
Aim the infrared remote control directly at the infrared sensor on the front of the lamp. The maximum
range is approximately 8 metres. In DMX and Slave modes, the remote control is deactivated. Battery
for IR remote control = CR2025.
Blackout
Auto programme
Colour macro
Strobe
Speed
Individual colour macros
Brightness
Manual colour mix
Fade programmes
- Colour preset
Main CPU Vx.xx
LED driver Vx.xx
LED xx°C / xx°F
Unit °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
xx:xx h Displays total operating time in hours and minutes
The blackout button is used to switch off all LEDs, regard-
less of operating mode enabled via the remote control.
Press the blackout button again to reactivate the previously
selected mode.
Auto-Programmes 1 - 6. Programme selection with
and . Programme run speed with
and . Brightness setting with
Colour Macros 1-15. Selection with
Strobe light for AUTO, FADE and MANUAL operating modes.
Press to activate. Strobe speed with
Press to deactivate strobe.
Setting the running speed for Auto and Fade programmes.
Individual colour macros 1-5. Selection with
.
Press and
Press and
colours. Adjust intensity with
Fade programmes Auto 1 - Auto 5. Programme selection
with and
and
and .
Direct selection of colour presets 0 to 9.
and
and
and
and to adjust brightness.
, , or to manually mix
and .
. Programme run speed with
. Brightness setting with and
and .
.
and .
and
and