Display Orientation; Ir Remote Control - Cameo FLAT STAR Bedienungsanleitung

SYSTEM SOFTWARE (inFo)
Use UP and DOWN to select the menu item inFO from the main menu and confirm with ENTER. Now press ENTER again to display the
software version.
-> ENTER

DISPLAY ORIENTATION

The orientation of the display characters can be rotated by 180° by pressing and holding the MODE and DOWN buttons simultaneously for
approximately one second.

IR REMOTE CONTROL

10
-> ENTER
Aim the infrared remote control directly at the infrared sensor on the front of the lamp. The maximum range
is approximately 8 metres. In DMX and slave modes, the spotlight's IR sensor is deactivated.
Blackout
ON/OFF
Auto programme
AUTO
Music-control
MUSIC
Programme
speed
Centre LEDs
A
+
SMD LEDs
B
Centre LEDs
C
SMD LEDs
0 - 9
Static mode
-/--
<- MODE
The blackout button is used to switch off the centre LEDs and the SMD
LED ring, regardless of operating mode enabled via the remote control.
Press the blackout button again to reactivate the previously selected
mode.
Press the AUTO button to activate the previously selected auto
programme. Repeated pressing activates each of the auto programmes
01 to 08. Category selection is performed with buttons A, B and C
(A = centre LEDs RGBWA+UV plus SMD LED ring, B = centre LEDs
RGBWA+UV, C = SMD LED ring). Programme speed is configured using
the arrow keys (left arrow = slower, right arrow = faster).
Press the MUSIC button to activate the previously selected mu-
sic-controlled programme. Repeated pressing activates each of
the music-controlled programmes 01 to 08. Category selection is
performed with buttons A, B and C (A = centre LEDs RGBWA+UV plus
SMD LED ring, B = centre LEDs RGBWA+UV, C = SMD LED ring). Adjust
the microphone sensitivity with MIC SENSITIVITY knob on the device.
No function
Programme speed is configured using the arrow keys (left arrow =
slower, right arrow = faster).
Press button A to activate the centre LEDs and the SMD LED ring for
stand-alone modes auto programmes, music-control and static mode.
Press button B to activate the centre LEDs for stand-alone modes auto
programmes, music-control and static mode.
Press button C to activate the SMD LED ring for stand-alone modes
auto programmes, music-control and static mode.
Press one of the buttons 1 to 7 to activate the static mode and one
of the 7 colour presets (1 = red, 2 = green, 3 = blue, 4 = yellow, 5 =
magenta, 6 = cyan, 7 = white. Buttons 8, 9 and 0 are non-functioning).
No function
No function