Slave Mode; Device Settings - Cameo SCUBA Bedienungsanleitung

STATIC MODE
Static mode makes it possible, as with a DMX control device, dimmer, strobe, effect wheel, and color wheel, to directly set values from 000
to 255 on the device. This allows the user to create individual scenes without needing an additional DMX controller. Access the selection
menu by pressing MODE. Using the UP and DOWN buttons, now select the "Mode" menu option and confirm via ENTER. Using the UP
and DOWN buttons again, select the "Static" menu option and confirm via ENTER. You can now again select the menu options "Dimmer",
"Strobe", "ColWheel", "Wave1", and "Wave2" using the UP and DOWN control keys, confirm via ENTER, and set the desired value from 000
to 255 with UP and DOWN. Confirm each entry via ENTER. The values and functions of Static mode correspond to the values and functions
in the DMX table. Press MODE again to return to the main screen.
Menu Mode
ENTER
Mode UP/DOWN Static

SLAVE MODE

Access the selection menu by pressing MODE. Using the UP and DOWN buttons, now select the "Mode" menu option (bottom row) and
confirm via ENTER. Using the UP and DOWN buttons again, select the "Slave" menu option and confirm via ENTER. Press MODE again to
return to the main screen. Connect the slave and master unit (same model, same software version) using a DMX cable, and activate the
standalone mode Static on the master unit. The slave unit will now follow the master unit.
Menu Mode
ENTER
Mode UP/DOWN Slave

DEVICE SETTINGS

Access the selection menu by pressing MODE. Using the UP and DOWN buttons, now select the "Settings" menu option (bottom row) and
confirm via ENTER. This will take you to the submenu for setting the submenu options (see table, select via UP and DOWN, confirm via
ENTER, change status via UP and DOWN, confirm via ENTER). Press MODE again to return to the main screen.
Menu
Settings
Settings
Display = Display backlight
DMXFail = Operating mode for DMX
signal interruption
DimResp. = Dimmer behavior
IRRemote = Activate / deactivate control
via infrared remote control
FacReset = Reset to factory settings
Static Static
ENTER UP/DOWN
Dimmer Strobe
ENTER ENTER
UP/DOWN UP/DOWN
Dimmer Strobe
000 - 255 000 - 255
ENTER ENTER
ENTER
Backlight On
Backlight Off
Hold
Blackout
LED
Halogen
On
Off
Factory
Reset?
Static
UP/DOWN UP/DOWN
ColWheel
ENTER
UP/DOWN
ColWheel
000 - 255
ENTER
permanently on
deactivates after approx. 30 seconds of inactivity
Last command is held
activates Blackout
The spotlight reacts abruptly to changes in the DMX value.
The spotlight behaves similar to a halogen spotlight with soft
changes in brightness.
control activated
control deactivated
Reset to factory settings:
Apply reset with ENTER, cancel with MODE
Static Static
UP/DOWN
Wave1 Wave2
ENTER ENTER
UP/DOWN UP/DOWN
Wave1 Wave2
000 - 255 000 - 255
ENTER ENTER
7