Tool Change; Keyless Drill Chuck Removal; Using The Bitholder; Switching On/Off - Parkside PBSA 12 C2 Originalbetriebsanleitung

GB IE NI
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.

Tool change

1. Rotate the keyless chuck (1) coun-
ter-clockwise, until the drill chuck
aperture (11) is large enough to
accommodate the tool.
2. Push the tool as far as possible into
the keyless chuck (1).
3. Rotate the chuck clockwise to
clamp the tool firmly.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.

Keyless drill chuck removal

To use the bitholder (14), you must remove
the keyless chuck (1).
1. Hold the keyless chuck (1) tightly
from the front. Pull or push the drill
chuck ring (2) in the direction of
the keyless chuck (1).
2. This unlocks the keyless chuck (1) and
it can be pulled off from the front.
10
CY
lowest torque,
highest torque.
Steps 1 - 19
Step .
3. In order to put the keyless chuck
(1) back in position, pull the drill
chuck ring (2) in the direction of
the keyless chuck. Push the keyless
chuck (1) on as far as it will go.
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (2).

Using the bitholder

After removing the keyless chuck (1) you
can use the bitholder (14).
1. Insert a suitable 6-point bit in the
bitholder (14). Because of the
6-point bit holder, it may be that
you need to rotate the bit slightly.
2. Slide the bit right into the bithold-
er (14). The bit is held firmly
by the duct and the magnetic
bitholder.
3. To remove the bit, simply remove
the bit from the bitholder (14).

Switching on/off

By using the on/off switch (9) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
1. Press the on/off switch (9) to start
the device. The LED work light
(10) lights up during operation.
2. To turn it off, release the on/off
switch (9).
When you move the direction
switch (6) to the middle position,
the device is secured against be-
ing switched on.