Torque Setting; Tool Change; Keyless Drill Chuck Removal; Using The Bitholder - Parkside PBSA 12 E4 Originalbetriebsanleitung

GB
1. Wait for the device to shut-down.
2. Clockwise direction: Press direc-
tion switch (6) to the right.
3. Anticlockwise direction: Press di-
rection switch (6) to the left.
4. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.

Torque setting

You can preset the maximum torque by ro-
tating the torque adjustment ring (3).
19+1 torque levels are provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 --> lowest torque,
Step
--> highest torque.
Screws: Steps 1 - 19
Drilling: Step .
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.

Tool change

1. Rotate the keyless chuck (1) towards
until the drill chuck aperture (9)
RELEASE
is large enough to accommodate the
tool.
2. Push the tool as far as possible into the
keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
26
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
To use the bitholder (17), you must remove
the keyless chuck (1).
1. Hold the keyless chuck (1) tightly from
the front. Pull or push the drill chuck
ring (2) in the direction of the keyless
chuck (1).
2. This unlocks the keyless chuck (1) and it
can be pulled off from the front.
3. In order to put the keyless chuck (1)
back in position, pull the drill chuck
ring (2) in the direction of the keyless
chuck. Push the keyless chuck (1) on as
far as it will go.
After removing the keyless chuck (1) you
can use the bitholder (17).
1. Insert a suitable 6-point bit in the
bitholder (17). Because of the 6-point
in
GRIP
bit holder, it may be that you need to
rotate the bit slightly.
Keyless drill chuck
removal
When setting the keyless chuck, a
25 mm bit may remain in the bit
holder (17).
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (2).

Using the bitholder

There is a magnet bit holder
18) on the left and right of the
(
housing.
You can attach one bit at a time to
the magnetic bit holder.