Sensor Wiring; Connecting Sensor Cables To Sensor; Table 3-1 Tb3 And Tb4 Wiring; Figure 3-5 Sensor Overview - Siemens SITRANS FUT1010 IP65 NEMA 4X Bedienungsanleitung

5. Tighten all TB1 and TB2 terminal block screws.
6. Replace I/O Board and secure with four screws paying careful attention to pin alignment.
7. Replace Access Cover, tighten captive screw and close transmitter case.
Table 3-1 TB3 and TB4 Wiring
Pin TB3 Function
1 AUX. 1 IN
2 AUX. 1 COM
3 AUX. 2 IN
4 AUX. 2 COM
Notes on Analog Input Modules
Dual Path Models
● All models use T1 to report temperature.
● The Analog Input of temperature takes priority over the built-in RTD (Resistive Thermal
3.2

Sensor Wiring

3.2.1

Connecting Sensor Cables to Sensor

①
②
③
Figure 3-5
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Liquid Quick Start
Operating Instructions, 6/2010, A5E02639182A Revision 02
Note
TB3 and TB4 are also active analog inputs. See wiring table below.
TB4 Function Use
AUX. 3 IN Iin1 Input
AUX. 3 COM Iin1 Common
AUX. 4 IN Iin2 Input
AUX. 4 COM Iin2 Common
Device) measurement of temperature when provided.
Line Taps (1/4" and 3/4")
Sensor Pipe Section
Sensor Enclosures
Sensor Overview
Description Behaviour
Analog current 4 to 20mA
input
referenced to
meter ground.
④
Junction Box
⑤
Upstream and Downstream I/O Cables
Connecting
3.2 Sensor Wiring
Load Wiring
200Ω 1000 ft.
Max w/o
factory
approval
25