ULTIMATE SPEED UPK 10 B1 Bedienungs- Und Sicherheitshinweise Seite 65

Step
1. Connect the
jump lead
18
of the power
bank with
compressor
to the
1
car-jump-
start-outlet
8
of the power
bank with
compressor
1
2. First connect
the red clamp
(A) to the
positive pole
of the vehicle
battery and
then connect
the black
battery
clamp B to the
negative pole
(see picture 1).
3. Starting up the
vehicle.
LEDs
Red Error LED
is continuously
lit on the jumper
cable .
18
Green Start LED
and the red Error
.
flash
LED
20
alternately.
The red Error
LED flashes, a
20
short alarm signal
sounds.
The red Error
LED flashes, a
20
continuous alarm
signal sounds.
The red Error LED
flashes once, a
20
continuous alarm
is sounded and
then followed by
two short alarm
sounds.
Green Start LED
and the red
19
Error LED flash
20
alternately. After
1–2 seconds only
the green LED
glows.
Meaning /
Error
The voltage
20
determined in
the power bank
with compressor
is not enough
1
to start the car.
Power bank with
19
compressor
ready.
The tempera-
ture is too high,
possibly due to
several jump
start attempts.
Battery clamps
(A) and (B) are
the wrong way
round.
It is caused by
a short circuit
or the battery is
leaking.
The connection
is correct.
19
Using the device
Solution
Charge
the power
bank with
compressor
Carry on
with step 2.
1
Disconnect
the black (B)
battery clamp
first and then
the red clamp
(A) from the
battery poles.
Start again
from step 1.
Carry on with
step 3.
GB/IE
.
1
65