ULTIMATE SPEED UPK 10 B1 Bedienungs- Und Sicherheitshinweise Seite 62

Using the device
In this case, once the preset
„ „
pressure has been reached and
the compressor automatically
switches off, switch the On/Off
switch for the compressor
(position 0).
Disconnect the inflatable item
„ „
from the compressed air hose
as described in the previous
17
section.
At the end of work, screw the
„ „
compressed air hose
off the hose connection
power bank with compressor
Subsequently, screw the cover
cap for hose connection
on to the hose connection
Attention: The hose connection
of the power bank with compressor
heats up during operation.
1
Make sure that you do not come into
contact with the hose connection
during operation to avoid suffering
burns. At the end of work, wait
for at least 10 minutes before you
unscrew the compressed air hose
back off the hose connection
the power bank with compressor
Please note: After switching on
the power bank with compressor
with the power bank switch
the device switches off automatically
after approximately 20 seconds if
the compressor is not started or if no
consumables are connected.
62 GB/IE
Please note: The digital pressure
gauge with pressure display
the power bank with compressor
1
off inflatable items have been pumped,
2
in which incorrect pressure can be
dangerous (e.g. tyres), find a
specialist unit with a gauged device
and check the pressure of the
inflatable item.
Tips for use
back
17
of the The device is not intended for
15
. continuous operation. The device
1
was designed to create air
back pressure – not an air flow.
16
. Please do not use the device for
15
more than 7 minutes at a time on
items with a large volume, to avoid
15
overheating and damage to the
device. Then let the device cool
down for at least 15 minutes.
We recommend first filling a
15
large-volume item with air, followed
by then using this device to generate
the target pressure.
If you need pressure greater than
17
of 3 bar for a vehicle tyre, do not use
15
. the device for over 3 minutes at a
1
time without stopping. Then let
the device cool down for at least
15 minutes.
1
,
9
Air pressure test with the
power bank with compressor
Please note: The digital pressure
gauge with pressure display
is not calibrated. Therefore, if
of
6
of
6