Faq; Troubleshooting - ULTIMATE SPEED UPK 10 B1 Bedienungs- Und Sicherheitshinweise

Using the device / FAQ / Troubleshooting
Attention: As soon as the
„ „
vehicle starts, remove the
jumper cable
bank with compressor
30 seconds and firstly disconnect
the black battery clamp (B) and
then the red clamp (A) from the
battery poles. Otherwise, it could
result in dangerous situations!
Leave the vehicle engine
„ „
running.
z FAQ
Q: Question
A: Answer
Q: How long does it take to
fully charge a mobile phone
with the device?
A: With a battery capacity of
3500 mAh: Approx. 3–4 hours
if connected to the USB port
5V /1A . Approx. 2-3 hours
12
if connected to the USB port
5V /2A . Please note that if the
11
device is switched on, it will continu-
ally use battery power while actual-
ly charging and this can extend the
charging time.
Q: How long does the power
bank with compressor
a full charge?
A: 3–6 months. However, we
recommend recharging the battery
monthly.
66 GB/IE
from the power
18
within
1
hold
1
Q: How is the power bank
with compressor
off?
A: After switching on the power
bank with compressor
power bank switch
bank with compressor switches off
automatically after approximately
20 seconds if the compressor is not
started or if no consumables are
connected. A manual switching off
of the device is not provided for.
z Troubleshooting
= problem
= cause
= remedy
The power bank with
compressor
charged, even though
all 4 indicator lights
permanently lit.
It is 60% charged after a long
period out of use or in storage.
Recharge the power bank with
compressor
1
section "Charge power bank with
compressor".
Power bank does not
respond when power bank
switch is pressed.
Deep discharge protection
active on the power bank with
compressor
1
switched
1
with the
1
, the power
9
is not fully
1
are
13
as described in the
9
.