Seca 606 Bedienungsanleitung Und Garantieerklärung Seite 16

Correct weighing
The weight determined continues to be displayed even after the load has been removed
from the scale (AUTO-HOLD function). This makes it possible to look after the animal first
and then make a note of its weight.
– Press the Start key with no load on the
scale.
se(a 8. 8 . 8 . 8 . 8 .
, and
utively in the display. The scale is then
automatically set to zero and ready to
use.
– If necessary, switch the weight display
(see page 16).
– Place the animal to be weighed on the
scale.
The display starts to flash, showing that
the scale is checking the stability of the
weight values. Only once stability pre-
vails is the displayed value stored. The
value is stored in the display until the
next weighing operation or until the
scale switches off automatically.
– Read the weighing result off the digital
display.
A new weighing operation can proceed
without the key being pressed again, as
putting a new load on the scale ensures
that a new weighing operation is per-
formed automatically.
– If a load greater than 100 kg or 220 lbs
is placed on the scale,
the display.
– For a renewed measurement without
removing the animal from the scale,
press the Hold/Tare key briefly.
– To switch off the scale, press the Start
key again.
Switching the weight display
The weight display can be switched between kilogrammes (kg) and pounds (lbs) or be-
tween kilogrammes (kg) and stones (sts).
– Switch on the scale using the green
Start key. Weight is initially displayed in
the last setting selected.
– To switch the weight display between
kilogrammes and pounds, press the kg/
lbs/sts key.
16
0. 0
appear consec-
St0P
appears in