Seca 606 Bedienungsanleitung Und Garantieerklärung Seite 14

Wall bracket
The display part can also be attached to the wall. The adapter wedge, wall bracket and
fixings are intended for this purpose.
– Attach the adapter wedge to the bot-
tom of the display. The adapter wedge
must be fitted so that the tip of the
wedge points backwards. First hook
the small hooks in the holes provided
for them and then engage the long lock-
ing hook in the bottom of the display by
pushing the hook inwards.
– Now fix the wall bracket to the desired
location on the wall, with the broader
part of the wall bracket facing down-
wards.
– Guide the connecting cable through the
opening at the bottom of the adapter
wedge and now hang the display part in
the wall bracket from above.
– The display part can be removed at any
time if required by taking it off the wall
bracket in an upward direction.
Connecting the connecting cable to the weighing platform
The connecting cable of the display part is used to transmit digital data which are consid-
erably less sensitive to interference than the otherwise conventional small analog meas-
uring signals. Ageing and wear on the cable and on the plug contacts thus have no effect
on the accuracy of the scale.
To make the connection, proceed as outlined below:
– Connect the cable from the display
housing to the socket under the plat-
form.
– Make a loop in the connecting cable
and clamp it in the slacking device on
the underneath of the scale.
– Screw the cable firmly in the slacking
device using the two screws.
The cable should not be drawn too
tightly between the socket and the
slacking device, otherwise weighing er-
rors will result.
– Then place the scale upright again.
14