Storage; Possible Faults - ATIKA KSHC 40-20 Originalbetriebsanleitung

Storage

Store machines that are not in use in a dry locked place

protected against frost and outside the reach of children and
unauthorized persons.
Before a longer period of storage carry out the following to

extend the power pruner's service life and ensure an easy
operation:
 Remove the battery
 thoroughly clean the device
 Remove the oil from the oil tank.

: Some chain oils tend to encrustations after a longer
period. For this reason the oil system should be
flushed before a longer storing with a chain saw
Before each fault elimination:
 switch off device
 wait for the power pruner to come to a standstill
 remove the battery

After each fault clearance, put into operation and recheck all security installations.
Fault
Power pruner does not
start after switching on
Power pruner works
with interruptions
Power pruner picks,
vibrates or does not
saw correctly
Power pruner does not
work with full power
Saw chain gets hot
No saw chain
lubrication
Cutting time with fully
charged battery too
short
24
Possible cause
 Li-Ion battery run down
 Lithium-ion battery
correctly
 Li-Ion battery too cold/ too warm
 Li-Ion battery, motor or switch defect
 external loose connection
 internal loose connection
 ON / OFF switch defective.
 Chain edgeless
 Chain worn
 Chain tension
 Chain not assembled correctly (teeth
face to wrong direction)
 The Li-Ion battery charge is low
 The Li-Ion battery is defect
 no oil in the tank
 oil flow canal blocked
 chain tension too high
 Chain edgeless
 no oil in the tank
 oil flow canal blocked
 Rechargeable battery is low
 Battery service life exhausted
 Chain soiled
 Chain blunt/worn
 Non chain lubrication
cleaner. Fill the cleaner up to the middle (approx. 50
ml) into the oil tank. Close the tank. Switch on the
power pruner without assembled guide bar and chain
until the complete cleaner has left the oil opening of
the power pruner.
 Put the saw chain for a short time into an oil bath and
enwrap it afterwards in an oil paper.
Put the chain guard in place.


Refer to the respective "Operating instructions" for further
information on the batteries and the charger.

Possible faults

Remedy
 Charge the Li- ion battery
not inserted  Check whether the lithium battery has engaged audibly.
 Allow the lithium battery to warm up/cool down
 Have the battery, motor or switch checked / repaired by a
licensed electrician or customer service or replaced by
original spare parts.
 Contact the customer service
 Chain must be regrinded or exchanged
 Exchange chain
 Check and adjust chain tension
 Assemble chain again
 Charge the Li-Ion battery (manual battery "Charging the
battery"
 Contact the costumer service
 Refill oil
 Clean oil flow canal
 Adjust chain tension
 Chain must be regrinded or exchanged
 Refill oil
 Clean oil flow canal
 Charge the Li-Ion battery (Abschnitt „Akku laden")
 Charging the rechargeable battery
 Clean the chain
 Chain must be reground or exchanged
 Replenish oil (Section "Chain lubrication")