Bigrep User Interface; Slicing Software - BigRep ONE Betriebsanleitung

Construction and Function
3

3.3. BigRep User Interface

The BigRep User Interface (BigRep UI – referred to as the interface below) des-
ignates the interface for controlling the BigRep ONE, and provides the user with
important information from the printer. The interface is operated via the device's
touchscreen (R).
Please also refer to
Note: This manual has been created for the BigRep UI version 0.7.4. Please refer to
the additional UI manual to check the specific content in case of updates.

3.4. Slicing Software

The slicing software enables you to generate a digital 3D model of the object you
would like to print. The slicing software transforms this model into data for the
printer, i.e. provides a code for the printer. The slicing software is not part of the
scope of delivery. For the slicing software, the General Terms and Conditions of
the respective manufacturer apply.
We recommend using the slicing program Simplify3D [www.simplify3d.com].
Please use the configuration file authorized by BigRep for set-up. It contains all rel-
evant default settings. You can also obtain the configuration file via the customer
portal.
Note
The manufacturer will not assume any liability for damages caused by incor-
rect configuration of the slicing software. Please only use configuration files
authorized by BigRep.
Please contact customer service [support.bigrep.com] if you have questions re-
garding the suitability of individual slicing software.
58
Chap. 5 Interface and
&
Chap. 6 Operation and Control
&
BigRep ONE
.