BigRep ONE Betriebsanleitung Seite 69

BigRep ONE
Out of Filament Response: Disable/Enable the Out of Filament
c.
response for the extruders. Set the length of time extruders should
wait for cool down after running out of filament
Pause Wait: Set a default pause wait position on the XY plane
d.
e. Temperature Control Calibration
f. Semi Automatic Bed Levelling
Note: Every time a new user accesses the UI, the code
on the terminal to activate the Advanced Menu
Terminal Menu
Direct G-code programming can be affected via the G-code input field. The termi-
nal also saves the last commands of the printer.
(Fig. 5-6)
Fig. 5-6: Terminal Menu
BigRep User Interface
5
M503 should be typed in
69