BigRep ONE Betriebsanleitung Seite 62

Installation and Commissioning
4
4. Open the Advanced Menu, go to Semi Automatic Bed Leveling Helper and
select Start Procedure. (Fig. 4-5)
The extruders will move to the first calibration point. Follow the lights
code to adjust the height of the bed in that point. (Table 4-1)
5. When finished, click on Next Point and repeat the process for each point.
62
Fig. 4-5: Advanced Menu
The bed is well leveled, move to the next point
The bed is too high, turn the screw clockwise until
both lights are on.
The bed is too low, turn the screw counter-clockwise until
both lights are on.
Table 4-1: Bed Leveling Light Codes
Fig. 4-6: Bed Leveling Helpery
BigRep ONE