You hear no sound from the speaker
♦
The volume of the speaker is set to minimum . Increase the volume .
A connected device does not charge
♦
The integrated battery is empty . Charge the battery .
♦
No connection to the device . Check the connection .
♦
The speaker is switched off . Switch on the speaker .
♦
Briefly press the
♦
The charging current of the connected device is too low or too high .
♦
The internal overcurrent protection may have been triggered . Disconnect the
connected device and connect the micro-USB charging port
source for a short while (see section Charging the speaker) . Afterwards, the
speaker can be used again .
NOTE
►
If the above-mentioned solutions do not resolve the problem, please contact
Customer Service (see section Service) .
Cleaning
CAUTION
►
Keep the protective cover
►
To avoid irreparable damage to the speaker, ensure that no moisture gets
into the speaker during cleaning .
►
Do not use caustic, abrasive or solvent-based cleaning materials . These
could damage the surfaces of the speaker .
♦
Clean the speaker only with a slightly damp cloth .
■
36
│
GB │ IE
button
to start the charging process .
closed during cleaning .
to a power
SLXL 20 A1