Aux In Mode - Silvercrest SLXL 20 A1 Bedienungsanleitung Und Sicherheitshinweise

AUX IN mode

CAUTION
► Use the speaker in AUX IN mode only in dry indoor environments and with
the supplied 3 .5 mm jack cable
You can also listen to music from a portable audio device connected via the
3 .5 mm jack cable
♦ Make sure that the speaker is switched off .
♦ Open the protective cover
♦ Use the 3 .5 mm jack cable
jack socket
♦ Press and hold the
You will hear a beep and the operating/charging LED
♦ Start playback on the audio device and adjust the volume to a moderate
level .
♦ Then set the desired volume using the
speaker .
♦ If you are no longer using the speaker in AUX IN mode, remove the 3 .5 mm
jack cable
NOTE
► If you connect a 3 .5 mm jack cable to the speaker during the playback of
audio files via Bluetooth
AUX input . The Bluetooth
3 .5 mm jack cable to the speaker .
► In AUX IN mode, it is not possible to use the
jump to the next/previous title .
► If the speaker stops receiving a signal while in AUX IN mode, the speaker
will switch off automatically after 10 minutes .
■ 34 │ GB │ IE
.
.
to connect the audio device to the 3 .5 mm
on the speaker .
button for about 3 seconds to turn the speaker on .
from the speaker and close the protective cover
® , it will switch playback automatically to the
® connection is also stopped if you connect a
.
button or
button
lights up blue .
button on the
.
or button to
SLXL 20 A1