Cleaning - Silvercrest SLXL 20 A1 Kurzanleitung

You hear no sound from the speaker
♦ The volume of the speaker is set to minimum. Increase the volume.
A connected device does not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ The speaker is switched off. Switch on the speaker.
♦ Briefly press the
♦ The charging current of the connected device is too low or too high.
♦ The internal overcurrent protection may have been triggered. Disconnect the
connected device and connect the micro-USB charging port
source for a short while (see section Charging the speaker). Afterwards, the
speaker can be used again.
NOTE
► If the above-mentioned solutions do not resolve the problem, please contact
Customer Service (see section Service).

Cleaning

CAUTION
► Keep the protective cover
► To avoid irreparable damage to the speaker, ensure that no moisture gets
into the speaker during cleaning.
► Do not use caustic, abrasive or solvent-based cleaning materials. These
could damage the surfaces of the speaker.
♦ Clean the speaker only with a slightly damp cloth.
│ GB │ IE │ NI
■ 16
button to start the charging process.
closed during cleaning.
to a power
SLXL 20 A1