Use Bluetooth Speaker Via Aux Stereo Jack; Switching Between Aux-In Connection And The Bluetooth Connection; Tws Pairing; Cleaning - Silvercrest SBL TW9 A1 Bedienungs- Und Sicherheitshinweise

Use Bluetooth speaker via
AUX stereo jack
Note: Music playback via cable takes priority
over music playback via Bluetooth
back from a Bluetooth
rupted once the jack lead
jack . The LED lights up green.
11 2
Switch on the sound source.
If the Bluetooth speaker is off, press and
®
hold the button
lights green and a signal tone sequence
sounds.
Start playback on the sound source and
adjust the volume to the highest possible vol-
ume. Adjust the volume on the speaker by
turning the volume control
anti-clockwise by using a finger.
Start playing music on the sound source.
Switching between AUX-in
connection and the Bluetooth
connection
To resume music playback via Bluetooth
nection, please unplug the jack lead
speaker. It will search for the previously paired
device (if any) and re-establish the Bluetooth
connection automatically.
Aux-in connection has a higher priority over the
Bluetooth
connection as following:
®
Once the jack lead
jack , the Bluetooth
11
is disconnected. The music playback is
switched to AUX-in only and the LED
lights up green.

TWS Pairing

This function is only available if two of these
speakers have been purchased.
Turn on both units of the speaker, make sure
both units haven't been connected to other
source devices via Bluetooth
Press the TWS button
which is default as the master unit. A beep will
28 GB/MT
. Music play-
®
source is therefore inter-
®
is plugged into the
13
until the LED LED
1 2
clockwise or
3
con-
®
from the
13
®
is plugged into the
13
wireless connection
®
2
.
®
on the speaker
7
sound. When pairing has been carried out
successfully, the white LED
slave unit stops flashing and a sequence of
beeps will sound.
The master unit still flashing LED
to pairing Bluetooth, connect with your play-
back device. Now these two units can be
played and controlled synchronously during
the Bluetooth playback mode.
Press the TWS button
the current TWS connection, the white circle
light LED of the connected slave unit
4
flashes and a signal of sound sequence.
Note: Which press the
will be default is master unit in Left channel,
slave unit is Right channel.
Note: TWS function only work on the same
model number with this product.

Cleaning

Switch the device off, remove all plugs, be-
fore cleaning!
Only clean the outside of the device using a
soft, dry cloth!

Storage during non-use

Store the product in a dry environment when
not in use. Protect it from dust and direct sun-
light. The rechargeable battery needs to be
charged regularly.

Troubleshooting

= Fault
= Possible cause
= Action
No functions
Battery drained.
Recharge the battery as described in
"Charging the battery".
of the connected
4
waiting
4
again to break
7
TWS button
7