Deactivate Tws Mode; Aux In Mode - Silvercrest SLXL 30 C1 Bedienungsanleitung Und Sicherheitshinweise

•
The power/charging LED (15) will slowly flash blue and the TWS LED (14) will flash green twice
approximately every five seconds.
The playback controls

9.3.2 Deactivate TWS mode

•
Briefly press (6) on any speaker to disable TWS mode. After a beep, the TWS LED (14) will
switch off on both speakers.
•
Playback will now continue through the main speaker only.
•
You can reactivate TWS mode by briefly pressing the
TWS coupling mode.

9.4 AUX IN mode

You can listen to music from a portable audio device connected to the 3.5 mm jack cable (C).
Use the supplied 3.5 mm jack cable (C) for AUX IN mode.
Once a 3.5 mm jack plug is inserted into the AUX IN jack (9) of the speaker when the
device is switched on, it will automatically switch to the AUX IN input.
Tracks cannot be skipped using the (2) and
•
Briefly press the on/off button
power/charging LED (15) will light up blue. Open the device cover (12).
•
Connect the audio device to the AUX IN jack (9) of the speaker. Use the supplied 3.5 mm jack
cable (C).
•
Start the playback on your audio device. Make sure the volume is set to a low level.
•
Then, adjust the speaker volume to the desired level using the
playback can be muted with the
•
Remove the 3.5 mm jack cable (C) from the AUX IN jack (9) once AUX IN mode is ended.
•
Close the device cover (12).
Do not operate the device near water when using the AUX IN connection as it is not
splash-proof when the device cover (12) is open.
(4), (2) and (3) work on both speakers.
(1) to switch the speaker on. A beep will sound and the
(4) button.
SilverCrest SLXL 30 C1
(6) button on both speakers to restart
(3) buttons in AUX IN mode.
(2) and (3) buttons. The
English - 13