Aux In Mode - Silvercrest SLM 10 C1 Bedienungsanleitung Und Sicherheitshinweise

•
The power/charging LED (12) will slowly flash blue and the TWS
LED (11) will flash green twice approximately every five seconds.
The two speakers will switch off automatically after about 30
minutes if no connection is made within that time. The
coupling process must be restarted after switching the
speakers on again. The playback controls
(2) work on both speakers.
9.3.2 Deactivate TWS mode
•
Briefly press
beep, the TWS LED (11) will switch off on both speakers.
•
Playback will now continue through the main speaker only.
•
You can reactivate TWS mode by briefly pressing the
on both speakers to restart TWS coupling mode.

9.4 AUX IN mode

You can listen to music from a portable audio device connected to the
3.5 mm jack cable (C).
Use the supplied 3.5 mm jack cable (C) for AUX IN mode.
Once a 3.5 mm jack plug is inserted into the AUX IN jack (8)
of the speaker when the device is switched on, it will
automatically switch to the AUX IN input. At this point, any
active Bluetooth
playback will continue via the AUX IN input.
Tracks cannot be skipped using the
in AUX IN mode.
(6) on any speaker to disable TWS mode. After a
®
connection will be interrupted and
SilverCrest SLM 10 C1
(4), (3) and
(6) button
(3) and (2) buttons
English - 47