Installation Of The Booth Lighting - EOS Infratec Classic Montage- Und Gebrauchsanweisung

The Infratec Classic control units wit-
hout pre-installed cables (item no. 94.4388)
shall be connected only with the cable resis-
tant to at least 90°C according to the given
below connection diagram.
• Only IR radiant heaters acc. DIN
60335 or IR heating foils with integrated
overheating protection (140°C) may be
connected.
• Follow the safety and installation infor-
mation provided by the IR radiant heater
manufacturer.

Installation of the booth lighting

• The connection cable is to be fed through
the hole drilled beforehand, and is to be
connected to the booth lighting.
• The booth lighting must always be moun-
ted as far as possible from the positional
spot of the infrared emitter, and may not
be directly beamed on.
Installation of the room sen-
sor
1. The heater sensor is mounted in the cen-
tre of the cabin ceiling.
2. Drill a hole to lead the cable through, pref-
erably through the middle of one of the
wooden boards.
3. Guide the sensor cable through the drilled
hole and attach it to the sensor line ac-
cording to the Fig. below.
Housing
Hole
Cabin ceiling
Centre sensor hous-
ing on middle section
Terminals
control unit
GB
Sensor circuit board
Sensor cable
S1 S2
in
21