Electrical Installations; Installation Of The Ir-Emitter; Mount The Infrared Emitter According To The Mounting Instructions - EOS Infratec Classic Montage- Und Gebrauchsanweisung

• Next, we suggest that the cable be laid be-
hind a node board. If a IR radiator has also
been installed in this node board, it must
be located below the control unit.
• Next, insert the bottom of the unit into the
prepared rectangular opening.
• Using the 4 included fastening screws,
attach the housing to the cabin wall.

Electrical installations

The electrical installation may
be only carried out by a registered
electrical contractor, while adhering to the
directives of the local EVU and the VDE.
nstallation of the IR-Emitter
Mount the infrared emitter according to the
mounting instructions.
• Unscrew the two screws of the clamped
covering for connecting the control cable
with the distributor block. Insert the plug
into the distributor block and retighten the
two screws.
The covering snaps over the circlips and
avoids the accidentally disconnection of
the joint.
20
IR control
Because of the higher starting current
has the unit to be fused by a 16A circuit brea-
ker with K characteristic.
GB
Node board
IR radiator
190 mm
181 mm
screws
clamped covering