Putting On The Carrying Strap; Operating The Leaf Blower; Turning On And Off; Working With The Leaf Blower - FLORABEST FLS 3000 B2 Originalbetriebsanleitung

The additional handle (10) can be lo-
D E F
cked in various positions. In order to
change the handle position, release
the screw with star grip (17), change
N O P
the handle position and tighten the
screw again.
X Y Z

Putting on the carrying strap

1. Place the carrying strap (12)
C D A E
across your shoulder and chest.
2. Adjust the length of the strap so
M N K O
that the snap hook is approxima-
tely 10 cm below your hip.
3. Attach the snap hook on the eye-
U
W X Y
let to insert the strap:
- in blow mode: position
- in suction mode: position

Operating the leaf blower

Danger of injury. Wear suit-
able clothing and work
gloves when working with
the device. Make sure that the
device is functioning properly
before every use. Make sure
that the collection bag and
the tube are assembled cor-
rectly and the carrying strap
is adjusted correctly for work.
After releasing the switch, you
must turn off the motor. Do
not use the device if a switch
is damaged. Personal protec-
tive equipment and a fully
functional appliance reduce the
risk of injuries and accidents.
After switching off the de-
vice, the impeller wheel
continues to rotate for some
time. Danger of injury due to
rotating tool.
G H
Q R
B F C G D
L P M Q N
V W X
Z
11b.
A B
11a.
A
K L
K
U V
U
Note noise protection laws and lo-
I J
cal regulations.

Turning on and off

S T
Before switching on device, make
sure it is not in contact with any ob-
jects. Ensure stable positioning.
1. Make a loop from the end of the
H E I F
extension cable and attach this
to the strain relief (5).
R O S P
2. Connect the machine to the pow-
er supply.
3. To turn on, push the
Y Z
on/off switch (4):
- in blow mode: to the right.
C D E F
- in suction mode: to the left.
B C D E
M N O P
4. In order to regulate the suction/
L M N O
blowing power, press the volume
W X Y Z
control (2).
V W X Y
5. To turn off, push the
on/off switch (4):
- in blow mode: to the left.
- in suction mode: to the right.
Working with the leaf
blower
The leaf blower may only be
used for the following pur-
poses:
- As a blower to pile up dry leaf
material or to blow material
out of places that are hard to
access (e.g. under cars)
- As a suction device to suck
up dry leaf material. The
device also functions as a
shredder in the suction func-
tion. The dry leaves are
shredded and their volume
is reduced, preparing the
material for later compost-
G B
J G H
T Q R
G H I J
F G H I
Q R S T
P Q R S
Z
M T
I J
S T
J
T
4 9