Maintenance And Storage - FLORABEST FLS 3000 B2 Originalbetriebsanleitung

G B M T
- when you are carrying out
cleaning or maintenance work
or replacing accessories;
- when the power or extension
cable is damaged; after con-
tact with foreign bodies or in
case of abnormal vibration;
• Do not vacuum any moist or
wet material or any liquids.
• Do not use the device in closed
or badly ventilated rooms. Do
not use the device near inflam-
mable liquids or gases. In case
of non-observance of these
directions, danger of fire or ex-
plosion exists.
• If an accident or fault occurs
during operation, immediately
switch off the device and dis-
connect at the plug. For the cor-
rection of faults, read the "Trou-
bleshooting" chapter or contact
our Service-Centre.
• Walk at a steady pace, do not run.
• Make sure that the mains volt-
age is compatible with the infor-
mation of the label.
• Keep the cable away from the
field of action and basically
play it out behind the operator.
• Do not carry the device by the
cable. Do not use the cable to
pull out the plug from the plug
socket. Protect the cable against
heat, oil and sharp edges.
• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifications,
must not be employed. Remove
the plug immediately from the
plug socket in case of dam-
age to the mains cable. Do not
touch the mains power supply
cable under any circumstances
4 6
until you have pulled the plug
out of the mains socket.

Maintenance and storage:

• Check the operational service-
ability and integrity of the de-
vice regularly in order to avoid
danger to the operator.
• Only use the replacement parts
that are supplied and recom-
mended by our Service Centre.
• Do not attempt to repair the
appliance yourself unless you
have specific training to do so.
Leave any work not listed in this
manual to our Service Centre.
• Keep the device in a dry loca-
tion and out of reach of children.
• Handle the unit with care.
Clean the ventilation slits regu-
larly; keep to the maintenance
instructions.
• Keep all cooling air inlets clear
of dirt.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the appliance if the
on/off switch does not work
properly. Always have a dam-
aged switch repaired by our
Service Centre.
• Do not overload your device.
Work only within the indicated
range of performance. Do not
employ any low power ma-
chines for heavy work. Do not
use your device for purposes for
which it has not been designed.