General Safety Instructions; Training; Preparation; Operation - FLORABEST FLB 3000 A1 Originalbetriebsanleitung

WARNING!
Dangerous feed orifice. Keep hands and
feet out of the openings while the ma-
chine is running.
ATTENTION: ENvIRONMENTAL PRO-
TECTION!
This device may not be disposed of with
general/household waste. Dispose of
only at a designated collection point.
General safety instructions
You must read, understand and follow these
operating instructions very carefully before operating
this machine. They should guarantee your safety and
the safety of others and should ensure a long and
fault-free service life for your machine.

Training

• Read through the operating instructions carefully.
Familiarise yourself with the controls and the
proper use of the device.
• Never allow the device to be used by children.
• Never permit children or persons who are not
familiar with these operating instructions to
use this device. The age of the operator may
be stipulated by local regulations.
• Never operate the device whilst other persons,
in particular children or animals, are nearby.
• The operator or user is responsible for all accidents
or hazards to other persons or their property.

Preparation

• Always wear sturdy shoes and long trousers
when operating the device.
• Do not wear loose clothing or jewellery as
these can be drawn into the air intake. Keep
long hair away from the air intake.
• Wear safety goggles during operation.
• The wearing of a face mask for protection
from dust is recommended.
• Before using check the power supply cable
and the extension cable for damage and signs
of ageing. Do not use the device if the cable is
damaged or worn out.
• Never operate the device with faulty coverings
or safety devices or with safety devices missing
- the attached debris bag for example.
• Only use weather-resistant extension cables
with sockets and plugs that comply with the
IEC standard 60320-2-3.

Operation

• Always lead the cable rearwards away from
the device.
• If a cable is damaged during operation then
disconnect the power supply cable from the
power source immediately. DO NOT TOUCH THE
CABLE BEFORE YOU HAVE DISCONNECTED IT
FROM THE MAINS.
• If the connection cable is damaged it must be
replaced by the manufacturer, a maintenance
representative of the manufacturer or similarly
qualified persons in order to exclude possible
hazards. If an extension cable is used, then this
must be dimensioned per H05VV-F (2 x 1.0 mm
or better.
• Do not carry the device by the cable.
• Disconnect the device from the power supply,
- If you leave the device,
- Before you remove potential blockages,
- Before you check, clean or work on the device,
- If the device starts to produce unusual vibrations.
• Only operate the device during daylight or
with good artificial lighting.
• Do not lean too far forward and keep your
balance at all times.
• Always make sure that you have stable
footing on slopes.
• Walk, never run.
• Keep all air intakes free of foreign bodies.
• Never blow debris towards bystanders.
• It is recommended that the device is only operated
at reasonable times of the day - so not early in
the morning or late in the evening - when people
could be disturbed by this.
• It is recommended to loosen debris with
rakes and brushes first and only then to start
with the blowing or vacuuming.
• It is recommended that dusty surfaces be
lightly dampened or that a mister is used.
• It is recommended to work with the full blast
tube length so that the air flow can work
close to the ground.
Maintenance and storage
• Ensure that all nuts, bolts and screws are firmly
tightened so that the device is constantly in a
safe working condition.
• Check the debris bag for wear or damage
regularly.
• Replace parts that are worn out or damaged.
GB
)
2
8