Cleaning And Maintenance; Cleaning Of The Surface And The Working Area; Cleaning After Use; Cleaning Of The Interior - EuroLite SPARK MASTER Bedienungsanleitung

Handling granules
Keep the granule away from moisture and ignation sources. Do not smoke. Avoid dust formation.
Always wear protective clothes, gloves and glasses. Always ensure sufficient ventilation. In case of fire,
use metal fire powder (fire class D) or dry sand as extinguishing agents.

Cleaning of the surface and the working area

Clean the machine and the working area after each use or at least once a day. Disconnect the device from power
and allow it to cool before cleaning. Only dry-clean the device. Use recommended protective gear. Avoid dust
formation. Any dust deposits are to be removed dust-free with a non-sparking tool and collected in a sealable
container. Bigger accumulations of dust should be covered with plastic foil before being removed. Do not raise
dust more than necessary during cleaning. Blow off dust only with an explosion-proof industrial vaccum cleaner
with dust class H. Caution! The material chemically reacts with water. Keep away from water!

Cleaning after use

We recommend you to perform the integrated cleaning function after each use to clean the channels inside the
heater from granule remnants. You can use the wireless remote control or your DMX controller for the cleaning
function. Once the machine has cooled down, turn the machine upside down to empty the granule container.
Remove the leftovers with a non-sparking tool and dust-free and store them in a sealable container until reuse.
Storing granule leftovers
Store any leftovers in the original containers if possible. The containers are to be marked explicitly and
permanently and stored air-tight in a dry, well-ventilated room until reuse. The storage temperature must not
exceed 20°C/68°F. Keep away from moisture. Do not store with materials that might cause harmful chemical
reactions with the granule.

Cleaning of the interior

The interior should be checked for granulate residues and cleaned after it has been used 5 times. Unscrew the
cover (see picture) and remove the residues in the area of the toothed belt, fan and electronic unit. Then reattach
the cover before reapplying power.
All other maintenance operations are only to be carried out by authorized dealers. Do not try to repair the device
by yourself as this may result in damage.
Should you need any spare parts, please use genuine parts. Should you have further questions, please contact
your dealer.

CLEANING AND MAINTENANCE

CAUTION!
Unscrew housing screws
24 • EN