Control Via Wireless Remote Control; Control Via Cable Remote Control - EuroLite SPARK MASTER Bedienungsanleitung

1 Disconnect the DMX cable from the machine.
2 Connect the supplied receiver for the wireless remote control to the CONTROLLER jack of the device. As the
base of the receiver is magnetic, you can attach it to the spark machine.
3 It is possible to control 3 separate groups of devices via the wireless remote control. To activate
the desired group, set the corresponding DIP switch 1, 2 or 3 to the lower ON position. DIP
switch 4 is without function.
4 The red indicator light on the remote control lights while the machine is warming up. When the Spark Master is
ready for spark output, the green indicator light will light.
5 To select the desired option for spark output, refer to the following table. Use button 2 to stop spark output.
During the output the display indicates "Volume Out" followed by the value set for the output volume.
6 Keep button 2 pressed for 10 seconds to activate the intergrated cleaning function for the heater. We
recommend you to do this after each use or in case of reduced output. You can abort the cleaning by
pressing the button 2 again.
READY
OUTPUT

CONTROL VIA WIRELESS REMOTE CONTROL

Button
1
2
3
5
7
4
6
8

CONTROL VIA CABLE REMOTE CONTROL

Disconnect the DMX cable from the machine.
1
2 Connect the supplied cable remote control to the CONTROLLER jack. As the base of
the receiver is magnetic, you can attach it to the spark machine.
3 Once the warm-up process is completed, the green control indicator on the remote
control will light up.
4 To activate the spark output, press the green button on the remote control. The display
indicates "Volume Out" followed by the value set for the output volume. While this
switch is kept pressed, the unit will emit sparks. As soon as you release the button, the
spark output will stop.
Function
Spark effect ON (continuous operation)
Spark effect OFF /
Keep pressed for 10 seconds to activate cleaning function
10-second spark effect
20-second spark effect
30-second spark effect
Spark effect ON Group 1 (continuous operation)
Spark effect ON Group 2 (continuous operation)
Spark effect ON Group 3 (continuous operation)
22 • EN