Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assigning the Remote Control to the Control Unit
The remote control needs to be assigned to the control unit when taking the
set into operation. For this, make the connections as described in chapter 4.
Switch off the power, and then switch it on again. Shortly press the button
once (within 3 seconds). All LEDs flash repeatedly to indicate that the
remote control has been assigned to the control unit.
Notes: One remote control may control a number of control units, however,
one control unit can only be controlled by a maximum of four remote controls.
If you wish to control several control units with a single remote control, the
devices must be paired. The easiest and fastest way for pairing several
control units at once is to plug them all into a single power strip. Once paired,
you can provide power as you would otherwise as sharing is only needed for
the pairing phase to ease the procedure. In the event of malfunctions, please
check the batteries and change them if necessary.
Resetting the Assignment
If necessary, the assignment can be reset. For this, switch off the power, and
then switch it on again. Keep the button
pressed for a few seconds
(within 3 seconds). All LEDs flash nine times to indicate that the assignment
has been reset.
Switching the LEDs On and Off
Touch the button
to switch on the LED strip. The LEDs light up
according to the last control program selected. Touch the button
to
switch them off.
Selecting the Lighting Color and Brightness
Slide your finger around the color ring to set the lighting color. The color ring
offers 60 contact points. Use the buttons
to adjust the color's
brightness.
www.eurolite.de
21
Werbung
Inhaltsverzeichnis
