Sound Control/Sensitivity; Dimmer Speed (Step Response); Master/Slave Mode; Control Via Ir-8 Remote Control - EuroLite LED PAR-56 Bedienungsanleitung

Sound Control/Sensitivity

Press the MODE button until the display shows S. You can select the desired sensitivity via the UP or
DOWN buttons.
Mode:
S S00 - S99 (S50 default setting)

Dimmer speed (step response)

Master/Slave Mode

Control via IR-8 remote control

1
When actuating a button, always hold the remote control in the direction of the sensor. There must be
visual connection between the remote control and the sensor.
2
The remote control is supplied with a battery inserted. An insulating foil between the battery and the
battery contacts prevents the battery from being discharged during storage. Prior to the first operation
remove the foil from the battery support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
3
If the range of the remote control decreases (10 meters as a
maximum), replace the battery. For this purpose, on the rear
remote control press the small bar with the groove to the right
same time remove the battery support. For operation, one 3 V
type CR 2025 is required. When inserting, pay attention that the positive pole of the button cell shows
upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Value
Press the MODE button until the display shows DIMMER.
You can select the dimmer speed: dC1 (response characteristics LEDs) or
dC2 (response characteristics of halogen lamps) via the UP or DOWN
button.
To the SLAVE-mode to adjust, press the mode button and choose SLA.
The so collimated appliances let itself now from one MASTER-device
control
CAUTION!
not be disposed of with regular domestic waste!
24/27
side of the
and at the
button cell
00088210.DOC, Version 1.1