Control Via Eurolite Ir-8 Remote Control - EuroLite LED PST-15W MK2 COB Bedienungsanleitung

Control via EUROLITE IR-8 remote control

1
When actuating a button, always hold the remote control in the direction of the sensor. There must be
visual connection between the remote control and the sensor.
2
The remote control is supplied with a battery inserted. An insulating foil between the battery and the
battery contacts prevents the battery from being discharged during storage. Prior to the first operation
remove the foil from the battery support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
3
If the range of the remote control decreases (10 meters as a
maximum), replace the battery. For this purpose, on the rear
remote control press the small bar with the groove to the right
same time remove the battery support. For operation, one 3 V
type CR 2025 is required. When inserting, pay attention that the positive pole of the button cell shows
upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Button
Blackout ON / OFF
SPR Internal programs; via „+/-„ the internal programs can be chosen
FL Flash on or off; via „+/-„ the speed can be regulated
SP Speed; via „+/-„the speed of the internal programs can be regulated
D DMX mode
SA Sound controlled mode
SL Master/Slave mode
S Setting DMX address; via 1, 2, 3, 4, 5, 6, 7, 8, 9 the DMX addresses can be set
R (red)
G (green)
Static colors; via „+/-„ the brightness can be regulated
B (blue)
W (white)
For example, to set the DMX starting address 245 via IR remote, please proceed as follows:
Press S for setting the DMX address. Press 2, followed by 4 and 5.
CAUTION!
not be disposed of with regular domestic waste!
26/30
Parameter
side of the
and at the
button cell
00099143, Version 1.1