Troubleshooting - Carson TYRANN 450 basic Betriebsanleitung

m. Troubleshooting
Please read this before something happens.
Problem
The model does not
move
Motor does not turn
The model reacts
incorrectly to the control
commands or flies
choppily
The model does not take
off
The rotors do not allow
shut down
The model vibrates
severely
The tail does not permit
stabilizing
CARSON 3D Helicopter Tyrann Basic 507019 • SE 507020
Cause
1. Check whether the transmitter and the receiver are
switched on
2. Check the battery voltage of transmitter and
receiver
3. Check whether transmitter and receiver frequency
agree
1. Motor is defective
2. Connection of controller and motor is loose
1. Check the state of the transmitter and receiver
battery charges
2. Transmitter antenna not completely withdrawn
3. Receiver antenna still wound up
4. Interference
1. Pitch value is not right.
2. Batteries are empty
1. Trim is not correctly adjusted
1. Check whether the principal rotors run true
2. Check whether the model is correctly balanced
1. One or more rotor blades are defective
2. The gyroscope is not adjusted correctly or is faulty.
Reparation
Switch transmitter and/or receiver on
Employ completely charged batteries
Possibly exchange the crystal
Exchange the motor
Connect the connector
Employ completely charged batteries
Extend the transmitter antenna totally
Unwind the receiver antenna completely
Make certain that there is no frequency
superposition by other transmitters and no
atmospheric disturbances
Check pitch value.
Charge the batteries or exchange them
Correct the trim on the pitch controller
Possibly balance the rotor blades
Possibly balance the rotor blades
Replace one or both rotor blades
Re-adjust or replace the gyroscope.
GB
17