Shut Down; Maintenance And Care; Precautionary Measures; Troubleshooting - Carson Smit Rotterdam Betriebsanleitung

SHut Down

Follow reverse procedure to shut down.
1. Turn off the model. Disconnect the power pack.
2. Turn off the transmitter.
• Never touch or hinder rotating parts and propeller.

maIntenance anD care

Your model must be regularly checked for proper control func-
tions. The drive and all electronic components must be checked
before each use. Ensure that allows all rotating and moving parts
move smoothly cultivation. Please clean the model only with a soft
moistened cloth.

precautIonary meaSureS

Precautionary measures for watertight com-
ponents
• Always dry off and clean immediately after use.
• Never store the components in a damp or wet state.
• To avoid corrosion, the product should not come into contact
with salt-water.

troubLeSHootIng

problem
model does not move
no control
Gb // 20
cause
Switch(es) on transmitter or/and model is/are "off" Switch on
Weak or no battery in the model
The overheat cut-out has stopped the model due
to overheating
Weak rechargeable battery/battery in transmitter
or model
• The motor and battery may become hot during operation. Take
care when you handle them.
• Remove the batteries from the model and the transmitter when
they are not in use.
important!
grease the drive shaft a regular basis. this also note when the
drive is running a bit rough, or is the use of more water than
usual inside the hull. remove the drive shaft by loosening the
catch and pull the shaft out the back. grease the drive shaft
enough with a optionally available suitable grease and mount
the shaft again accordingly.
• The housing of the speed controller and servo are waterproof.
The connections to the power pack, the motor and the receiver
are not watertight!
• Take care of the exposed connections and keep them away from
liquids and damp.
• Make sure that electronic components such as the receiver,
power pack, servo and motor are protected from water and
damp.
Remedy
Insert fully charged battery
Switch off the receiver. Allow the RC model to
cool down for approximately 30 minutes
Insert fully charged battery or new battery