Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Shut down
Follow reverse procedure to shut down.
1. Turn off the model. Disconnect the power pack.
2. Turn off the transmitter.
Maintenance and Care
Your model must be regularly checked for proper control functions. The drive and all electronic components must be checked before each use.
Ensure that allows all rotating and moving parts move smoothly cultivation. Please clean the model only with a soft moistened cloth.
Important!
Grease the drive shaft a regular basis. This also note when the drive is running a bit rough, or is the use of more water than usual inside
the hull. Remove the drive shaft by loosening the catch and pull the shaft out the back. Grease the drive shaft enough with a optionally
available suitable grease and mount the shaft again accordingly.
Precautionary measures
Precautionary measures for watertight
components
• Always dry off and clean immediately after use.
• Never store the components in a damp or wet state.
• To avoid corrosion, the product should not come into
contact with salt-water.
• The housing of the speed controller and servo are waterproof.
The connections to the power pack, the motor and the receiver
are not watertight!
Troubleshooting
Problem
Model does not move
No control
• Never touch or hinder rotating parts and propeller.
• The motor and battery may become hot during operation. Take
• Remove the batteries from the model and the transmitter when
• Take care of the exposed connections and keep them away from
• Make sure that electronic components such as the receiver, power
Cause
Switch(es) on transmitter or/and model is/
are "off"
Weak or no battery in the model
The overheat cut-out has stopped the model
due to overheating
Weak rechargeable battery/battery in trans-
mitter or model
CARSON RC Premium Boat Grand Captain 500106002
care when you handle them.
they are not in use.
liquids and damp.
pack, servo and motor are protected from water and damp.
Remedy
Switch on
Insert fully charged battery
Switch off the receiver. Allow the RC model to
cool down for approximately 30 minutes
Insert fully charged battery or new battery
G
25
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
