Preflight Check List - Carson TYRANN 450 basic Betriebsanleitung

f. Preflight check list
GB
The following actions should be
performed by the operator prior to every
flight.
1. Ensure that the blades have been balanced and are equally
tight on the blade grips. Note: if you hold the helicopter on
its side the blades should be tight enough that they do not
drop even if model is shaken.
2. Inspect the helicopter for any loose wiring, screws,
fasteners, connectors, prior to flying.
3. Turn on your transmitter first followed by connecting the
battery to the speed controller in the helicopter, you should
also ensure that the 3D switch is set to normal and the
throttle is set to off, i.e. all the way down.
4. Walk away from the helicopter with the antenna collapsed
to check range, you should be able to walk 50 paces away
and still have full control over the helicopter. If the distance
is significantly less check antenna wire and connections on
the receiver of the helicopter.
Overview RC Mode 2: left control stick is throttle/pitch and tail rotor
Roll
Down
Roll left/ right
rolls left
Pitch
raise/lower height control
10 CARSON 3D Helicopter Tyrann Basic 507019 • SE 507020
Up
rollr right
left right
ascend
up
climb/accelerate
down
sink
descend/decelerate
5. Check the CG (center of gravity) by having the main blades
at 12:00 o'clock and 6 o'clock. Lift the helicopter by the fly
bar and observe the landing skids. The skids should be level
with the ground and not leaning forward or backward. If it
leans they lean adjust the position of the battery by sliding it
backwards or forwards until the skids remain level.
6. If this is your first flight, it is strongly recommended that you
use the provided training gear before attempting to fly. the
training gear will prevent the model tipping, a tip over which
can cause blade and or main shaft damage. once you have
learnt to hover your helicopter you can remove the training
gear.
7. Fully extend the antenna prior to lift-off this will ensure you
have maximum radio range.
Nick
Up
Nick forward/ backward
backward
forward
Tail
rotor
right
Turn right/ left
left
Down
forward
backward
left
right
left right