Wilo -Veroline IP-E Einbau- Und Betriebsanleitung Seite 48

7.4.4 Blocking the pump
Setting of the control systems and parameters can be blocked
against unauthorised access.
When blocking is active only faults can be acknowledged by pres-
sing the tuning button.
17
7.4.5 Fault menu
18
LC display
LC display
Blocking can be activated or deactivated in two ways:
Via the IR monitor
x
By setting the corresponding DIP switch in the converter terminal
x
box. The following menu then appears:
When the DIP switch is active no other settings can
CAUTION!
be made, but faults can still be acknowledged.
The current condition is displayed statically.
Switching blocking on/off:
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
To exit the menu the DIP switch must be reset (see above). The status
display with or without key appears.
In the event of a fault condition the relevant fault is indicated by E = error
and the code No.
For the code Nos. and their meanings see table (section 11.6).
ENGLISH
Setting
Setting
43