Malfunctions And Troubleshooting; Technical Data; Maintenance - Salvis Master VisionPRO Betriebsanleitung

5.

Malfunctions and troubleshooting

Should you encounter any difficulties with your appliance, check unit with the aid of the following
table:
FAULT
The green control lamp or the
illuminated ring do not light up
when the unit is switched on
The unit is switched on but
does not heat up
If you cannot remedy the fault
− Switch off the unit and disconnect from the power supply
− Do not open the housing
− Notify your repair workshop
6.

Technical data

Technical data
Item number
Total connected
Voltage
Fuses
Noise level
We reserve the right to make technical changes
7.

Maintenance

D Have your appliance checked and maintained at regular Intervals.
Typical maintenance work comprises safety, functional and leakage tests.
D Only qualified electricians may carry out installations, maintenance work and repairs.
D Use only original accessories and original spare parts.
D We recommend you conclude a maintenance contract with a repair service.
POSSIBLE CAUSE
Unit is not switched on at the
mains
No power supply
Emergency cut­off has been
activated
Energy optimizer switched on
prior to the unit does not activ­
ate the heating
Heated hob
1 heating zone
VP606000, VP606010, VP606500,
VP606020
MA606000, MA606010, MA606500,
MA606020
976733, 976741, 976768, 976776
1 kW
400 V 2N 50/60 Hz
2 x 16 A
< 70 dB (A)
SOLUTION
Activate mains switch
Notify power utility company
Have unit checked by author­
ized workshop as it might be
faulty. Reconnect mains fuse.
Check energy optimizer
Heated hob
2 heating zones
VP606050, VP606550
MA606050, MA606550
976784, 976792
2 kW
400 V 2N 50/60 Hz
2 x 16 A
< 70 dB (A)
en
13 / 24