Ignite The Pilot Light And Burner - Salvis PLGGH - PL880649 Originalbetriebsanleitung

en
4.2

Ignite the pilot light and burner

Gas igniter
Gas control for burner, front
Set the burner flame
. After ignition, release the gas control, lightly press and turn to high heating capacity.
. To set from high to small flame, lightly press the gas control and turn to the small flame symbol.
● Low heating capacity, small flame symbol
● High heating capacity, high flame symbol
30 / 68
DANGER! If there is a smell of gas in the room where installed, do not ignite the
gas flame!
Risk of explosion!
. Shut off the gas tap on site!
. Do not switch on or off electrical appliances!
. Open windows and doors! Thoroughly ventilate the room where installed with a
draught!
. After sufficient ventilation, determine the location of escaping gas!
. Inform the standby service of the gas supplier!
Pilot light - under the
pilot burner cover
● When the appliance has not been used for a
longer period of time: e. g. the main shut-off
device was closed, it may take slightly longer
before the pilot light ignites (the gas supply
has to fill up with gas again).
. Press in and hold the gas control, turn to igni
tion symbol .
. Using the gas igniter, ignite the pilot light.
. After igniting the pilot light, keep the gas con
trol pressed for approx. 5 - 10 seconds,
‒ so that the thermocouple can sufficiently
heat up and
‒ the gas supply is not automatically shut off
again (automatic safety pilot).