Specifications - PeakTech 1035 Bedienungsanleitung

CAUTION!
Note on using the supplied safety test leads according the IEC /
EN 61010-031:2008:
Measurements in the field of overvoltage category CAT I or CAT II
can be performed with test leads without sleeves with a maximum of
up to 18mm long, touchable
measurements in the field of overvoltage category CAT III or CAT IV
test leads with put on sleeves, printed with CAT III and CAT IV must
be used, and therefore the touchable and conductive part of the
probes have only max. 4mm of length.

3. Specifications

Accuracies are: (% of reading + no. of digits) guaranteed for 1 year,
23° C ± 5° C, less than 75 % R.H.
DC Voltage
Range Accuracy
200 mV
2000 mV
20 V ± 0.5 % + 2 digit
200 V
600 V
Input Impedance:
Overload protection:
AC Voltage
Range Accuracy
200 V
± 1.2 % + 10 digit
600 V
Input Impedance:
Frequency range:
Overload protection:
Indication:
metallic probe, whereas
Resolution
100 µV
1 mV
10 mV
100 mV
1 V
> 1 M on all ranges
600 V DC or peak AC on all ranges,
rms
in 200 mV range 220 V
rms
Resolution
100 mV
1 V
> 1M on all ranges
45 Hz to 450 Hz
600 V DC or AC in all ranges
rms
Average (rms of sine wave)
-18-
for