HANSGROHE PHARO Duschtempel 100 Montageanleitung Seite 47

O p e r a t i n g / s e r v i c i n g E L 4 0
(EL = electronic version)
Motor adjustment
The motor should be adjusted
after the Shower Temple has
been put into operation to
adapt it to local home
conditions. These depend on
the type of heating used and
the available warm water
temperature.
Attention: These specifica-
tions can change later when
a heating system is installed
or modified, or the water
temperature is changed.
...and it is as simple
as this:
The Shower Temple must be in
"stand-by" mode (display has
background lighting, no func-
tions are active). The hand
shower is activated automati-
cally during motor adjustment.
First press the >42° ( )
button as well as the Body
shower ( ) button until
tCH is displayed.
Now press the Mode-button
( ): Motor adjustment now
runs automatically. It takes ab-
out 7 minutes.
Pressing the Mode ( )
button saves the motor
adjustment.
The letter C is displayed when
motor adjustment has finished.
Light on/off
The shower lighting can be
switched on and off with the
Light ( ) button.
Attention:
Water emerges: Therefore
check the position of the
hand shower!
Pressing the >42° ( )
button stops motor adjustment
prematurely (the last valid
factory setting curve is then
applicable).
The lighting switches off
automatically after the shower.
Factory setting: 2 minutes;
individually adjustable
1 – 50 min (refer to Page 50)
47