HANSGROHE PHARO Duschtempel 100 Montageanleitung Seite 42

M o u n t i n g r o o f a n d i n s t a l l a t i o n u n i t
1
2
3
4
5
6
7
8
9
15
42
10
11
12
13
14
If the installation is completed and the shower tray is earthed
then join transformer with the mains supply. Do not seal the
installation unit so condensation can escape.
Mounting installation unit
Pre-mount fixing plate with wing nut on holding angle.
Turn in star knob screw (11) until it stops. Connect supply
hoses, the supplies for hot water is marked red (right).
Check the connections for leaks
Pull supply hose (14) and the lighting cable (15) over the
support frame. Slide cable (17) into the hollow pipe. Make
sure to leave enough length so the shower panel can be taken
off for servicing.
Press installation unit (1) above the holding angle (2) against
the wall and slide it carefully downwards until it stop on the rim
of the shower tray.
Centre installation unit in the corner. Fix installation unit with
wing nut and clamping plate.
Loosen star knob screw and turn on 1,5 cm.
Mounting roof
Pre-mount on the support frame the screw (9) with washer (8)
and nut (7).
Slide roof between installation unit and the wall holder.
Fit screw (9) into the cut out of the roof (10). Loosen (12) wing
nut. Slide distance equaliser (13) and roof against the corner.
Tighten star knob screw (11), secure roof and distance
equaliser with wing nut (12) the same for nut (7).
Join supply hose (14) with over head shower.
Join plug (15) with supply cable of the installation unit.
Put on roof cap and column caps.