Taurus Spin Fresh Bedienungsanleitung Seite 22

to avoid overflowing and splashing.
According to criteria, fry with the lid
open or closed.
- When the food has been fried suffi-
ciently, lift the basket and position
it in the support in order to allow
the excess oil to drain from the food
(Fig. 5)
- Empty the basket.
- Change the oil approximately every
15 or 20 frying operations, or every 5
– 6 months if not used frequently.
- In order to minimize the genera-
tion of acrilamida during the frying
process, avoid to reach dark brown
colours on the fried food, remove any
burnt leftovers from the oil container,
food rich in scratch (such as potatoes
or corns) should not be fried at tem-
peratures higher to 170ºC.
- In order to minimize the generation
of acrilamida during the cooking
process, avoid to reach dark brown
colours on the foodstuffs.
Spin function:
This fryer has a spin function to
remove oil from the food.
- Close the lid.
- When frying is done, raise the
basket to its limit.
- Use the control to programme the
spin time (Fig. 6)
- Select speed 1 or 2 depending on
the food type (see attached table)
- Select the speed before selecting
the time
- The basket will begin to spin.
Once you have finished using the
appliance:
- Select the minimum position (MIN)
Manual Spin Fresh.indb 22
using the thermostat control.
- Select position 0 using the cooking
time control.
- Select position 0 using the spin
time control.
- Unplug the appliance to the mains.
- Close the lid.
Practical recommendations:
- Fry a few pieces of bread to remove
the smell of used oil.
- For food with a high water content,
it is better and quicker to fry in two
lots with less food than in just one.
This will reduce the risk of splashes
and spillage.
- To ensure that frying is homoge-
neous and crunchy, frying can be
carried out using a two time process.
This system consists of first frying the
food until it is reasonably well done
and then frying again using very hot
oil to brown the food.
- Olive oil with a minimum acidity
level is recommendable for frying.
- Do not mix different oils.
- Wash potatoes before frying to stop
them from sticking.
Safety thermal protector:
- The appliance has a safety device,
which protects the appliance from
overheating.
- In the event of overheating, the
thermal safety mechanism will be
activated and the appliance will
stop operating. When this occurs the
appliance should be disconnected
from the mains and left to cool. Then
press the rearming button, situated at
the back of the electrical circuit, with
the tip of a pen or similar in order to
01/08/11 12:33